Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
This equipment must only be used by trained, competent and healthy persons, or under the supervision of a trained and competent person. Warning!
Certain medical conditions may affect user safety; if in doubt, consult your doctor.
Before each use, check:
The effectiveness of this anchor system depends on proper sizing of the safety components, namely:
1: blocking half-moons
2: blocking cone
The dimension opposite must be checked before each use: if the size is smaller, have your equipment
checked or discontinue use.
Also check before each use: that there is no sign of deformation or oxidation on any IN-LOCK
component. Pay particular attention to the anchorage ring and the crimping on the components (on
the blockage cone, the half-moons, placement indicator and the anchorage ring). Check that the main
cable is not cut or deformed. If there is any doubt, the equipment must not be used until a qualified
individual has carried out a complete check.
Do not remove, add or replace any component of the product.
Chemical products: do not use the device in the event of contact with chemical products, solvents or fuels which could affect its operation.
TECHNICAL SPECIFICATIONS:
Stainless steel and aluminium. Cable: Galvanised steel: diam. 6 mm. Weight: 150 g +/- 10 g. R>12 kN.
KRATOS SAFETY certifies that this equipment has been tested in accordance with the standard EN 795:2012 Type B.
COMPATIBILITY FOR USE:
An anchorage point must be used in a fall arrest system as defined in the product's factsheet (see EN 363) in order to guarantee a maximum arrest force
of 6 kN on the user. A fall arrester harness (EN361) is the only body support device permitted for use. It may be dangerous to create your own fall arrest
system in which each safety function may interfere with another safety function. As such, before each use, refer to the recommendations for use for each
of the system's components.
INSPECTIONS:
The recommended service life of this product is unlimited (in accordance with the annual examination by a competent person authorised by KRATOS
SAFETY), but it may be reduced according to use and/or the results of the annual inspections.
The equipment should be inspected if there is any doubt, or following a fall, and at least annually, by the manufacturer or a competent person* and in
strict compliance with the manufacturer's periodic inspection procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check
its strength and therefore the user's safety.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
The product data sheet should be completed (in writing) after each verification. The date of inspection and date of the next inspection must be indicated
on the data sheet. It is also recommended to put the date of the next inspection on the product.
MAINTENANCE AND STORAGE: (these instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and in its packaging. Clean with water, wipe with a cloth and hang in a ventilated
room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have got wet during use.
The device must be stored in a cool, dry and ventilated room, and in its packaging.
9
Advertenties
Inhoudsopgave
