Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
machine is not running, and support the speed-changing by slightly rotating the
work spindle.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage the
lock button
Switching-off:
press the on/off switch and let release it again
Attention!
!
In case of every stop of the machine or a power cut, the
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
The Stirrer EHR 23 / 2.4 S is equipped with an electronic switch. With this switch
the speed can be regulated according to the pressure on the button. Only use the
electronic switch when you want to start or stop the machine in order to avoid
material splashing around. A permanent use with reduced speed can cause an
overload because the motor then gets less cooling air and therefore the machine
will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist.
Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the machine.
In case of failure, a repair has to be carried out by an authorised service
workshop.
13
Advertenties
Inhoudsopgave
