Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Charging station
Fig. 22
Contacts
Clean the contacts of the battery and the shearer with a dry cloth as nec-
essary.
NOTE!
If not using daily, store shearer and charging station in the packaging sup-
plied with them. When in use daily, we recommend to put clipper and re-
serve battery in the charging station.
7
Troubleshooting
y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly or
not at all
Motor is not running
Translation of the original instructions / Small animal clipper
Cause
Clipperhead is not well
engaged
Turning lever is defective
Clipper blade is blunt
Clipper blades have not
been correctly ground
Clipper blades are not oiled Oil clipper blades every 15 minutes
The animal's hair is wet
Hairs jammed between top
and bottom blades
Clipperhead has too little
clipping pressure
Battery is dead
Contacts dirty
Faulty battery
Smell of burning from
the motor housing. Motor
burned out
1. Disconnect the charging station
from the power supply.
2. If necessary, take away hairs from
both charging cavities.
3. If required, clean the contacts (1)
and (2) with a dry cloth.
Rectification
Engage the clipperhead correctly
when the motor is running
Replace turning lever (S)
Have top and bottom blades resharp-
enend by service centre (S)
Only clip dry hair
Take off clipperhead, push the top
blade half away from the clipperhead,
take away hairs between top and
bottom blade
Have clipperhead inspected (S)
Charge battery
Switch clipper off and clean the
contacts
Replace battery
Have motor and / or electronics
replaced (S)
17
Advertenties
Hoofdstukken
Inhoudsopgave
