Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2.2 Changing the battery
When the battery is unloaded, the clipper is turned off by a protective circuit.
Fig. 17
Fig. 18
6.2.3 Changing the clipperhead
Fig. 19
Fig. 20
6. Fit the favoured clipperhead to the blade hinge and fold it on to the
switched-on clipper by light pressure. (fig. 15, 16, 17).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by
a specialist. In that case, contact your service centre.
Translation of the original instructions / Small animal clipper
1. Move the switch to position "0"
(fig. 4).
2. Push the battery interlock (2) on
both sides inward and pull the bat-
tery (1) out of the clipper.
3. Insert charged battery (1) into the
shearer (2), until the battery lock
is locked in on both sides.
1. Move the switch to position "0"
(fig. 4).
2. Push the interlock clipperhead.
3. Fold
the
clipperhead
when the interlock clipperhead is
pressed.
4. Take off the clipperhead.
5. Clean the opened hinge by the
help of the provided brush.
ahead
15
Advertenties
Hoofdstukken
Inhoudsopgave
