Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2.4 Lubrication
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (fig. 22).
CAUTION!
Unsufficient lubrication of the clipperhead causes heating and a reduced
durability of clipper and blades, as well as a reduction of the battery runtime.
Therefore:
Lubricate the blades sufficiently during the clipping (at least every
X
15 minutes), so that they do not drain (fig. 22).
Only use the lubricants prescribed by the manufacturer.
X
NOTE!
Only use our special oil or a paraffin oil meeting the ISO VG 15 specification.
The provided oil is non-toxic and produces no irritation on contact with the
skin or the mucous membranes. This paraffin oil degrades to some 20%
after 21 days (CEL-L-33-T-82).
Fig. 21
CAUTION!
Remove all the leaking, used up or excessive grease from all the lubrication
points, and it is to be disposed in accordance with the local regulations.
6.2.5 Cleaning
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (6.2.4 Lubrication).
Clipperhead and hinge
Clean clipperheads und hinge between the different clippings.
16
Translation of the original instructions / Small animal clipper
The blades must be oiled before,
during and after every use. When
the blades of the clipper are leaving
stripes or are running with reduced
speed, this is a signal that oil is re-
quired. Place a few drops of oil ahead
and laterally on the clipper blades
(see arrows in fig. 21). Wipe off the
excessive oil with a smooth, dry cloth.
Lubrication sprays do not have suffi-
cient oil for a good lubrication, but
serve for cooling the blades. Imme-
diately change damaged or crenated
blades to avoid injuries.
Advertenties
Hoofdstukken
Inhoudsopgave
