Advertenties
Beschikbare talen
Beschikbare talen
18.2
Cause and Action
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error
Vacuum unit is not
functioning
The first weld on the
cut off piece of the roll
is not being carried
out.
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
19 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials. However,
they also contain damaging substances, which were necessary for their
functionality and safety.
Possible cause
Power plug is not plugged
in
Defective power cable or
plug
Defective electrical socket
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Please note
Rectification
Plug in mains plug!
Send device to Customer Service
Select another electrical socket
Follow the steps in the chapter
"Vacuum packaging in a bag
originating on the roll"
Position the bag correctly
Select another bag
Clean the seals and retry correctly
once they are dry
Open the cover on the unit and let
it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp edges
on the content
Open the bag again and clean the
upper internal part of the bag and
remove any foreign matter that
might be on the welding bar before
you weld the bag shut again.
41
Advertenties
