Advertenties
Beschikbare talen
Beschikbare talen
6 Before use
6.1 Inserting the batteries 5
en
CAUTION
Do not use damaged batteries.
CAUTION
Always replace the complete set of batteries.
CAUTION
Do not mix old and new batteries. Do not mix batteries
of different makes or types.
1.
Release the catch on the underside of the tool and
open the battery compartment cover.
7 Operation
7.1 Making settings in the menu
1.
To enter the menu, press the "Menu" button.
2.
To access the individual menu items, press the
"Down" arrow button or the "Measure" button.
NOTE The selected menu item is highlighted in gray.
3.
Press the "Left" or "Right" arrow button to change
the setting for the selected menu item.
4.
To leave the menu, press the "Menu" button again.
5.
The current settings are adopted and the selected
default mode then displayed.
7.1.1 Switching on the electric current sensor
Activate the electric current sensor from the "AC sensor"
menu option. At the default setting, the electric current
sensor is switched off. The electric current sensor is used
only for classification of electric cables. Even when the
power is switched off (cables not live), electric cables are
shown as objects.
NOTE
To avoid the possibility of incorrect readings, e.g. in damp
concrete or when touching the surface being scanned,
switch the AC sensor on only when it is actually needed.
7.1.2 Setting default mode
In the "default mode" menu item you can set the scanning
mode that is to be displayed after the tool is switched on.
22
Printed: 25.01.2018 | Doc-Nr: PUB / 5151174 / 000 / 04
2.
Insert the batteries in the tool. Close the cover and
check that it engages in the closed position.
NOTE Take care to observe correct polarity (see
symbols in battery compartment).
The Battery status indicator in the display on the
tool indicates battery charge state.
3.
Make sure that the battery compartment is closed
properly.
6.2 Switching the tool on / off
1.
Switch the tool on by pressing the on/off button.
The status LED lights green. The default mode se-
lected from the menu is indicated.
2.
When the tool is already switched on, press the
on/off button: The tool switches off.
NOTE If the warning "Please change batteries" is
displayed, the settings will be saved and the tool
then switches itself off automatically.
NOTE If no scan is made or no button is pressed,
the tool will switch itself off automatically after 5
minutes. You can adjust the switch-off time in the
menu (see 7.1.5).
NOTE
The factory setting for the scanning mode is "Universal".
7.1.3 Switching the signal tones on and off
In the "Signal tones" menu item you can select whether
a signal tone is also emitted when an object is detected
by the tool.
NOTE
In the default setting, the signal tone is active.
7.1.4 Setting the brightness
Set the display brightness in the "Brightness" menu item.
NOTE
The factory setting is "Maximum" (maximum brightness).
7.1.5 Setting the switch-off time
In the "Cut off time" menu item select the time interval
after which the tool shall switch itself off automatically
when no scan is made or no button is pressed.
NOTE
The factory setting is"5 min".
7.1.6 Setting the language
Set the desired dialog language in the "Language" menu
item.
NOTE
The factory setting is "English".
Advertenties
