installation
safety
installation
4.
safety
Only qualified contractors should carry out installation, commis-
sioning as well as maintenance and repair of the product.
4.1
general safety information
We guarantee trouble-free operation and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
4.2
instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
5.
Product description
The product is equipped with a pressure reducing valve.
5.1
standard delivery
The following are delivered with the appliance:
- Drain outlet
- Adjusting pipe with 90° leak water connection
- 2 pipe bends
5.2
accessories
Accessories are available for connecting a second draw-off point.
A special adjusting pipe with 90° leak water connection (∅ 40 mm)
for installation below a kitchen sink is available from specialist
wholesalers.
www.stieBel-eltron.com
6.
installation
6.1
Product installation
Note
When installing this product, also observe the operating
and installation instructions of the water heater.
1 Drain outlet
2 Safety valve
3 Adjusting pipe with 90° leak water connection
f Flush the line thoroughly before installation.
f The blow-off aperture of the safety valve must remain open
to the atmosphere.
f Install this product in place of an angle valve in the cold
water supply line. For this, connect the safety assembly with
the pressure tap and the water heater using tapered ring
fittings.
Note
Observe the minimum dimension between the drain and
stench trap (see chapter „Specification/Dimensions").
Note
You will require a special adjusting pipe with 90° leak
water connection if you are installing this product below
a kitchen sink.
f Replace the adjusting pipe of the stench trap with the adjust-
ing pipe with leak water connection supplied.
f Secure the drain outlet to the adjustable pipe and create the
connection to the safety assembly using the pipe bend.
1
2
3
svmt |
9