Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Damage to the appliance and environment
Appliance disposal
f This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.3
Units of measurement
Note
All measurements are given in mm unless stated other-
wise.
2.
Safety
2.1
Intended use
This appliance is designed for the storage of heating water and
for DHW heating.
Any other or additional use is inappropriate, in particular usage
with alternative storage media. Observation of these instructions
and of instructions for any accessories used is also part of the
correct use of this appliance..
Any modifications or conversions to the appliance void all war-
ranty rights.
2.2
Safety information
DANGER Scalding
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
Where children or persons with limited physical, sensory
or mental capabilities are allowed to control this appli-
ance, ensure that this will only happen under supervision
or after appropriate instruction by a person responsible
for their safety.
Children should be supervised to ensure that they never
play with the appliance.
Damage to the appliance and environment
The appliance is under pressure.
During the heating process, expansion water will drip
from the safety valve. If water continues to drip when
heating is completed, please inform your heating con-
tractor.
2.3
Test symbols
See type plate on the appliance.
3.
Appliance description
DThe appliance combines DHW heating and a buffer cylinder for
the hydraulic separation of heating system and heat pump. The
DHW is heated via a corrugated stainless steel internal indirect
coil that functions like an instantaneous water heater. The volume
of the cylinder is an energy store for DHW heating.
The appliance is ideally suited to operation with a heat pump.
In addition, a threaded immersion heater and an auxiliary heat
source can be connected.
SBS W SOL
These appliance types are also equipped with an internal indirect
coil for solar DHW heating and central heating backup.
4.
Cleaning, care and maintenance
f Have the function of the safety assembly and electrical safety
of the fitted special accessories regularly checked by a hea-
ting contractor/electrician.
f Never use abrasive or corrosive cleaning agents. A damp
cloth is sufficient for cleaning the appliance.
4.1
Scaling
f Almost every type of water deposits limescale at high tempe-
ratures. This settles inside the appliance and affects both the
performance and service life. If a flanged immersion heater
is installed, the heating elements must be descaled from
time to time. A heating contractor who knows the local water
quality will tell you when the next service is due.
f Check the taps regularly. You can remove limescale deposits
at the tap outlets using commercially available descaling
agents.
5.
What to do if ...
5.1
... the appliance develops faults
The outlet flow rate
The perlator in the tap or
is low.
shower head is scaled up
or contaminated.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the serial
number from the type plate (no. 000000-0000-000000):
f
Clean and/or descale
the perlator or the sho-
wer head.
1U
Advertenties
Hoofdstukken
Inhoudsopgave
