Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
N and
as shown in the diagram (see fi gure) and
proceed with the connection process, tightening the
terminal screws as far as possible.
4. Position the remaining wires on terminals 1-2-3 and
tighten the screws.
5. Fix the power supply cable in place by fastening the
cable clamp screw.
6. Close the terminal board cover by tightening the
screws V.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the appliance data plate (see Technical
data table).
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum contact
opening of 3 mm installed between the appliance and the
mains. The circuit-breaker must be suitable for the charge
indicated and must comply with NFC 15-100 regulations
(the earthing wire must not be interrupted by the circuit-
breaker). The supply cable must be positioned so that it
does not come into contact with temperatures higher than
50°C at any point.
Before connecting the appliance to the power supply,
make sure that:
• The appliance is earthed and the plug is compliant with
the law.
• The socket can withstand the maximum power of the
appliance, which is indicated by the data plate.
• The voltage is in the range between the values
indicated on the data plate.
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only.
! The manufacturer declines any liability should
these safety measures not be observed.
TABLE OF CHARACTERISTSICS
Dimensions
34x39x44
Oven HxDxW
Volume
58 l
Useful
width 42 cm
measurements
depth 44 cm
relating to the oven
height 18 cm
compartment
Voltage and
see data plate
frequency
Rapid Ø 180 mm:
Electric Hob
Rapid Ø 145 mm:
Max. Hob Power Absorption:
Directive 2002/40/EC on the label of
electric ovens.
Standard EN 50304
ENERGY LABEL
Energy consumption for Natural
convection – heating mode: Static
mode;
This appliance conforms to the following
European Economic Community
directives: 2006/95/EC dated 12/12/06
(Low Voltage) and subsequent
amendments - 04/108/EC dated
15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent amendments.
2002/96/EEC
1275/2008 (Stand-by/ Off mode)
GB
2000 W
1500 W
7000 W
13
Advertenties
Inhoudsopgave
