Advertenties
Beschikbare talen
Beschikbare talen
Connecting the inverter
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
The installation surface must be level and sufficiently strong.
NOTICE!
A
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Fasten the inverter as follows (fig. 3, page 4):
➤ Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the
holders.
7
Connecting the inverter
NOTICE!
A
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
7.1
Connecting the MSI212 and MSI224
The connection is made via a plug that is connected to a 12 V vehicle socket
(for MSI 212) and a 24 V vehicle socket (for MSI 224).
The middle pin of the plug must be connected to the positive wire (fig. 5 1,
page 4) and the two side brackets of the plug must be connected to the
negative wire (fig. 5 2, page 4).
NOTICE!
A
Make sure that the plug is firmly connected in the vehicle
socket. If the connection is loose, the plug may heat up.
The rating of the vehicle socket, the supply cable, and the fuse
must be at least 15 amps. Do not put in a fuse with a higher
rating.
24
SinePower
EN
Advertenties
