Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation
This appliance must be installed in accordance with
the instructions in the manual and the IEC guidelines
relating to electrical fittings in bathrooms. The towel
warmer must be connected to a circuit breaker
protected by a suitably qualified electrician.
1. Choose the mounting position, maintain the
required minimum distances. (see fig 1)
2. Mark the positions for your mounting holes on the
template if there are no existing marks. Stick the
template on the wall and drill the holes with an 8mm
bit. (see fig 2)
Note: Excessive drilling diameter is strictly
prohibited.
3. Insert the expansion plugs into the drilled holes and
screw screws "B" into the top 2 holes. (screw "B" is
equipped with a limiting device and is screwed into
the screw with the limited position) (see fig 3)
4. Use screw "E" through the hole of the lower
mounting bracket "D" and screw it into the
expansion plug at the bottom. Adjust "D" to the
horizontal direction as shown in fig 4.
5. Locate where the mounting holes on the back of
the towel warmer hang from the top 2 screws. (see
fig 5)
6. Slide the device to get the screws in the correct
positions as shown in fig 6.
16
Advertenties
Hoofdstukken
Inhoudsopgave
