Advertenties
Beschikbare talen
Beschikbare talen
Caution: Voltage is applied to the terminals in
this mode even when no electrical equipment is
connected.
Mode 4 | Regeneration mode
Suitable for the regeneration of batteries after
short-term extreme discharge. The battery
should be disconnected from the vehicle electri-
cal system. For batteries with a capacity of more
than 14 Ah.
Press the mode select button (8) to select mode
4. The LED display
carry out any subsequent action, the regeneration
mode starts automatically after a few seconds and
(15) flashes. If the battery
the LED display
is more or less completely flat, the LED
may flash for up to 3 hours. During this period, a
constant current level of 1500 mA flows into the
battery to restore its capacity. Regeneration mode
is deactivated after a maximum of four hours. If the
battery has still not been fully charged, the charger
switches to a normal charging mode. After success-
ful charging of the battery, the LED will light up
(11) and (10) go out.
After a short delay the unit switches automatically
to trickle charge mode and the LED
Note: This mode is only suitable for 12 V batteries
Note: In this mode the battery must be completely
charged! Do not interrupt the charging process
prematurely.
04.2015 | C7 | Battery charger
C7-Komplett-060613.indd 23
(16 V boost)
(15) lights up. If you do not
(15)
(11) flashes.
Mode 5 | 24 V (28.8 V / 3.5 A)
Suitable for batteries with a capacity of more
than 14 Ah in normal state. Charging mode for
WET batteries and the majority of GEL batteries.
Press the mode selection button (8) to select
Mode 5. The LED
(16) lights. If no further action
is then taken, charging starts automatically after
a few seconds and the LED (10) will also light up.
After successful charging of the battery, the LED
will light up
(11) and (10) go out.
After a short delay the unit switches automatically
to trickle charge mode and the LED
Mode 6 | 24 V (29.4 V / 3.5 A)
Suitable for batteries with a capacity of more
than 14 Ah in cold state or for many AGM batteries.
Press the mode selection button (8) to select
Mode 6. The LED
(13+16) will light up. If no
further action is then taken, charging starts auto-
matically after a few seconds and the LED (10) will
also light up. After successful charging of the bat-
tery, the LED will light up
After a short delay the unit switches automatically
to trickle charge mode and the LED
23 | english
(11) flashes.
(11) and (10) go out.
(11) flashes.
Automotive Aftermarket
06.05.15 13:52
Advertenties
