Advertenties
Beschikbare talen
Beschikbare talen
english | 22
Mode selection
► Select the required mode by pressing the
mode selection button (8).
► The LED for the desired mode will light up.
The following modes are available:
Mode 1 | 12 V (14.4 V / 7 A)
Suitable for batteries with a capacity of more
than 14 Ah in normal state. Charging mode for
WET batteries and the majority of GEL batteries.
Press the mode selection button (8) to select
Mode 1. The LED
action is taken, then charging will automatically
start after a few seconds and the LED (10) will also
light up. After successful charging of the battery,
the LED will light up
After a short delay the unit switches automatically
to trickle charge mode and the LED
Mode 2 | 12 V (14.7 V / 7 A)
Suitable for batteries with a capacity of more
than 14 Ah in cold state or for many AGM batteries.
Press the mode selection button (8) to select
Mode 2. The LEDs
If no further action is taken, then charging will
automatically start after a few seconds and the LED
(10) will also light up. After successful charging of
the battery, the LED will light up
go out.
After a short delay the unit switches automatically
to trickle charge mode and the LED
Automotive Aftermarket
C7-Komplett-060613.indd 22
(12) will light up. If no further
(11) and (10) go out.
(11) flashes.
(12+13) will light up.
(11) and (10)
(11) flashes.
Mode 3 | Back-up mode / Power supply unit
Back-up mode
Suitable for providing back-up. On certain vehicles
it is essential not to disconnect the vehicle electron-
ics from the power supply on battery replacement.
In such cases, the C7 can be used to power the
vehicle electronics whilst changing the battery.
Connection to battery in vehicle
Press the mode selection button (8) to select
Mode 3 and the LED
(14) flashes.
Note: In back-up mode, switch off all electrical
equipment (e. g. ignition, radio, lights).
Note: In back-up mode, as soon as the circuit is
interrupted , the charger switches automatically
to standby mode.
Caution: To avoid possible destruction, never
charge the battery for a lengthy period in this mode.
Power supply unit
Without connection of battery
Keep the mode selection button (8) pressed for
approx. three seconds. The supply LED
light up as soon as the integrated switch is triggered.
Power is supplied at a level of 13.6 V (± 0.25 V) / 5 A
(± 10 %).
Note: Suitable as power supply unit for 12 V equip-
ment e. g. refrigerator.
Note: The charger is provided with overload
protection in this mode (max. 6.0 A).
Note: There is no reverse polarity protection in
this mode (refer to "Connection").
Battery charger | C7 | 04.2015
(14) will
06.05.15 13:52
Advertenties
