Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
GENERAL
INFORMATION
no : double regulation function disabled (Front=Back)
yES : intelligent regulation function enabled. Only the
"front" heating element will regulate around the set
point. Thus, the "back" heating element will activate if
temperature is one degree below the set point, acting as
a booster.
09
Clr : FACTORy SETTING
Press and hold the "OK" key for 10 seconds to reset Set
points temperatures and user parameters in this menu
to factory default settings.
10
SOFTWARE VERSION
xx.x
12
END: EXIT THE PARAMETER'S MENU
Press the "OK" key to exit installation parameter menu
and return to normal operation.
5. MAINTENANCE, REPAIR
AND DISPOSAL
WARNING: Disconnect electrical supply before carrying
•
out any maintenance activity.
•
The product can be cleaned using a soft damp cloth.
Do NOT use chemical or abrasive cleaners as thy will
damage the surface finish.
•
The radiator is equipped with an overheat protection
that cannot be reset (melt fuse). This overheat protection
disconnects the current if the radiator becomes too hot
(e.g. when covered).
•
If the supply cord is damaged, it must be replaced by
the manufacturer, his service agent or similar qualified
persons in order to avoid a hazard.
•
The radiator is filled with an exact amount of
environmental friendly vegetable oil. Any repairs that
require the radiator to be opened shall therefore only
be carried out by the manufacturer or his approved
agent. Please contact the manufacturer or his agent
in case of leakage.
•
When scrapping the radiator, follow the regulations
concerning the disposal of oil.
| 26
LVI0014_Manual Ramo_Parada_ZW_v5.indd 26
All manuals and user guides at all-guides.com
6. WARRANTy
The product is covered by a 10 years warranty except for
the electrical and electronic components that are covered
by a 2 years warranty.
7. TECHNICAL
CHARACTERISTICS
MEASURING ACCURACy
ENVIRONMENTAL:
- Operating temperature
- Shipping and storage
temperature
SETTING TEMPERATURE RANGE:
- Comfort, Reduced
- Frost Protection
CONTROL CHARACTERISTICS
ELECTRICAL PROTECTION
POWER SUPPLy
CONTROLS CONSUMPTION:
(in Standby Mode)
OUTPUT
DIRECTIVES & STANDARDS :
The thermostat has been
designed to comply with
the following Directives
and Standards.
CERTIFICATES
0.1°C
-10°C to +50°C
-30°C to +70°C
+5°C to +30°C
+5°C to +10°C
Double proportional band
(PI & PWM)
Class II – IP44
230 VAC - 50 HZ
~ 3.5 W
TRIAC 230 VAC 8A
• EN 60730-01
• EN 61000-6-1
• EN 61000-6-3
• EN 61000-4-2
• Low Voltage Directive
2006/95/EC
• EMC Directive 2004/108/EC
• R&TTE Directive 1999/5/EC
• RoHS Directive 2002/95/EC
• NF Electricité Sécurité
• NF Electricité Performance ***
24-10-13 15:58
Advertenties
Inhoudsopgave
