Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Press the START/MODE Button (1) for >3 seconds to activate the LED light (3)
•
Pressing the START/MODE Button shortly, switches between the Light-Modes:
•
- WHITE continuous light
- traffic warning lights: flashing RED light and BLUE light
- WHITE light SOS Morse code (3x short – 3x long – 3x short)
In order to deactivate the LED light, press the START/MODE Button (1) again for >3 seconds
•
USB-PORTS
ATTENTION: Don´t use the USB-Ports during jump-starting !
Use the built-in 5 Volts USB-OUTPUT-Ports (2) and (7) to power or charge your USB-devices: e.g.
cell phones, car electronics ...
The micro-USB Port delivers a current up to 1 A (5 Watts)
The USB Port delivers a current up to 2.1 A (10,5 Watts)
Usage: Turn the unit on by pressing the START/MODE Button (1). The battery indicator (4) will light up and your
devices can be charged.
Note: If no device is connected to the unit, it will power-off automatically.
STORAGE
After use, this unit should be fully charged and stored in a dry, well ventilated place out of the reach of children.
Recharge at the latest every 6-8 month. Do not store in locations where temperature may exceed 60°C/140°F or
get lower than 0°C/32°F. Protect the unit from direct sunlight, heat and moisture.
JUMP-STARTING YOUR CAR (12V ONLY !)
NOTE: Read your car´s owner's manual! Some vehicle manufacturers have special requirements before
jumpstarting the vehicle (e.g. fuses that have to be removed or certain security demands). Some vehicles
manufacturers place the battery in the cargo area or trunk. These vehicles often have designated jump-start
terminals.
ATTENTION: After each failed attempt to jumpstart your car, take a break for at least 1 minute to avoid
overheating.
1. Preparation: Make sure there's no oxide or dirt on the vehicle battery's terminal.
2. Open the dust cover (9) and connect the delivered set of jumper cables to the EC5 OUTPUT (8) port of
the unit. Attention: Don´t touch or connect the red to the black clamp.
3. Connect the red (+) clamp to your vehicle´s positive (+) battery terminal.
4. Connect the black (–) clamp to your vehicle´s negative (-) battery terminal (GND).
5. Make sure to have correct, good and reliable connections
6. Turn the unit on by pressing the START/MODE Button.
7. NOTE: If the car battery is absolutely discharged (voltage lower than 3V), the device can not
identify the battery and boost it (the battery is considered broken).
8. Start your car.
9. NOTE: The device is powering off automatically after 1 Minute to prevent overheating. Please start your
car within that period.
10. Remove the black and then the red clamp (Remember that the red and black clamp must not touch) und
disconnect the cables from unit´s EC5 OUTPUT (8)
All manuals and user guides at all-guides.com
9
Advertenties
Inhoudsopgave
