Initial operation
h) Recording on the hard disk of a computer
•
The USB interfaces can be used as inputs and outputs.
•
During recording, the USB interface is used as output. It always carries the same signal as the output MASTER
OUTPUT (15), is however not influenced by the volume control.
•
To record the mixing desk signal, simply start the recording function of your audio recording software (inform
yourself in the manual or the help function of the software).
Handling
•
Never plug the power plug into a mains socket immediately after the device has been taken from a cold to a warm
environment. The condensation water created thereby may damage the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
•
Never disconnect power plugs from the mains socket by the cable. Always pull out it out of the mains socket
holding it by the contact surfaces provided for this purpose.
•
Remove the plug mains unit from the wall socket if the device is not in use for a longer period of time.
•
For safety reasons, disconnect the power pack from the mains socket in case of an electrical storm.
•
Do not listen to excessively loud music for long periods of time. This may damage your hearing. This especially
applies when listening via headphones.
Maintenance
Regularly check the safety of the mixer, for example, for damage to the power unit or the housing.
If you have a reason to believe that the device can no longer be operated safely, disconnect it immediately and secure
it against being operated unintentionally. Pull the power unit out of the socket.
It can be assumed that safe operation is no longer possible if:
•
there is visible damage to the device or the power unit
•
the device no longer works
•
it has been stored for a long time under unfavourable conditions
•
it was exposed to extraordinary stress caused by transport
Always observe the following safety instructions before cleaning or servicing the mixer:
All manuals and user guides at all-guides.com
33