Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Use Bluetooth
AUX stereo jack
Note: Music playback via cable takes prior-
ity over music playback via Bluetooth
playback from a Bluetooth
interrupted once the jack lead
into the jack
. The LED
2
green.
Switch on the sound source.
If the Bluetooth
speaker is off, press and
®
hold the
button
LED lights green and a signal tone se-
quence sounds.
Start playback on the sound source and
adjust the volume to the highest possible
volume. Adjust the volume on the speaker
using the
button
ton
(down).
10
Start playing music on the sound source.
Carry out TWS pairing
Note: The TWS (True Wireless Stereo) func-
tion is only available if two of these products
have been purchased and both have the same
model number.
Turn ON both products and make sure
they are both not connected to another
device via Bluetooth
Press the button
11
which will then by default set it as the
"primary" unit. A beep will sound. When
pairing between both products has been
carried out successfully, the LED
connected "secondary" unit stops flashing
and a sequence of beeps will sound.The
"primary" unit LED
waiting to pair with the playback device.
Once the "primary" unit has successfully
paired with the playback device both the
"primary" and "secondary" units can be
played and controlled synchronously during
Bluetooth
playback mode.
®
12 GB/IE/NI
speaker via
®
. Music
®
source is therefore
®
is plugged
13
lights up
5a
until the signal
9
(up) or the
but-
6
.
®
on one of the products
of the
5a
will still be flashing
5a
Press the button
11
TWS pairing connection, the LED
the connected "secondary" unit flashes
and a signal tone sequence sounds.
Note: The product which had its button
pressed first will become the "primary" unit
(in the left audio channel), and the other
unit will then by default become the "sec-
ondary" unit (in the right audio channel).
Switching between AUX-in
connection and the
Bluetooth
connection
®
To resume music playback via Bluetooth
nection, please unplug the jack lead
the speaker. It will search for the previously
paired device (if any) and re-establish the
Bluetooth
connection automatically.
®
Aux-in connection has a higher priority over
the Bluetooth
connection as following:
®
Once the jack lead
the jack
, the Bluetooth
2
nection is disconnected. The music play-
back is switched to AUX-in only and the
LED
lights up green.
5a
Lantern light on/off/dimmer
There are 2 different lantern light opera-
tions:
At OFF mode
- Press and hold for 1 second: 100 %
lumen
- Then press once: 50 % lumen
- Then press once: switch off the light
At ON mode
- Press once: 100 % lumen
- Then press once: 50 % lumen
- Then press once: switch off the light
again to break the
on
5a
11
con-
®
from
13
is plugged into
13
wireless con-
®
Advertenties
Hoofdstukken
Inhoudsopgave
