Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
the skin. Wear suitable protective gloves
at all times if such an event occurs.
Please note, when the protective cover
is open, the device is not protected from
water entering the device. In this case, only
use the device in a dry environment.
The speakers shall not be exposed to drip-
ping or splashing when the protective
cover
is open.Only charge the speak-
3
ers in a dry environment.
Before use
Before use, verify the package contents
are complete and undamaged!
Place the device on a level, even surface
for operation.
Charging
The integrated rechargable battery must
be charged prior to first use.
Note: This product may not be charged
via the USB port of notebooks etc.
When the integrated rechargable battery
is drained, a signal will notification sound
every 2 minutes. The LED
red. The integrated rechargable battery
should then be charged as soon as possible.
Depending on the volume and the age of
the battery, the operating time for the device
is approx. 8 hours playback music or 7.5
hours lantern light (at 50 % lumen) play-
back when fully charged.
Open the protective cover
Insert the USB-C plug of the charging ca-
ble
into the USB-C socket
12
Bluetooth
speaker. Insert the USB plug
®
of the charging cable into the USB port
on a PC or a USB adapter (not included in
scope of delivery).
10 GB/IE/NI
3
Establishing a Bluetooth
connection:
is blinking
5b
.
3
of the
1
Note: The LED
5b
whilst charging and goes out once charg-
ing is completed. The charging time for a
drained battery is approx. 6.5 hours.
Note: The speaker cannot be used whilst
charging.
Once charging is complete, remove the
USB-C plug of the charging cable and
close the protective cover so the device is
splash-proof again.
Using the Bluetooth
speaker
Press and hold the Play/Pause
until the signal LED
9
and a signal of sound sequence. The
speaker will now attempt to connect to
the playback device (e.g. smartphone or
computer).
Remove all plugs from the AUX stereo
jack
before you establish Bluetooth
2
radio link.
Switch on the playback device and approve
the connection. Please note the require-
ments of the software on the playback
device. The LED
5a
and a signal tone sequence sounds.
The speaker identification on the playback
device will be SBL 5WL A1.
Press and hold the
for 2 seconds until the signal LED
flashes white and a signal tone sequence
sounds. The speaker will now attempt to
connect to the playback device (e.g. smart-
phone or computer).
The maximum range of the connection is
approx. 10 m, but may be reduced to the
geometry of the space (obstructing furni-
ture, walls, etc.).
will light up red
®
button
flashes white
5a
®
®
will light up white
Bluetooth
button 11
5a
Advertenties
Hoofdstukken
Inhoudsopgave
