Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
b) Installation into the radio recess
• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and
pulling it off from the unit.
• Unlock the installation frame with the two unlocking keys (fig. 1, no. 1).
• Pull the installation frame towards the back of the system (fig. 1, no. 2).
• Insert the frame into the respective recess in the vehicle (fig. 2).
• Bend down some clips in the installation frame until the frame is securely fastened in the recess (fig. 3).
• When you have made all the electrical contacts (see "Electric connection") insert the device into the
frame until it locks in (fig. 4). Make sure that you insert the device into the installation frame in the correct
orientation (the contacts for the front control panel must be at the bottom).
• Replace the plastic frame to the device at the front.
Keep the two unlocking keys in a safe place. You will need them for a later removal of the car
radio.
• Protect the device against vibrations with the bolt at the back of the unit.
• In most vehicles, such a safety fastening is provided for. If this is not the case in your vehicle, fasten the
device with the enclosed punched metal strip.
For the fastening, proceed as follows:
All manuals and user guides at all-guides.com
33
Advertenties
Hoofdstukken
Inhoudsopgave
