Download Inhoudsopgave Inhoud Print deze pagina

Explanation Of Buttons; Extra Notes; Cleaning And Maintenance; Replacing The Batteries (Fig F ) - Tunturi Cardio Fit R25 Rower Gebruikershandleiding

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 31
Odo
- Automatically accumulates the Total distance for all exercise
sessions�
- Range: 0�0 ~ 99�99 KM/ 0�00 ~ 9999 KM�
NOTE
• Odo can only be reset by a batteries exchange�
RPM
Rowing speed for the workout�
- Rowing-strokes Per Minute�
Calorie
Automatically accumulates Calorie burnt when exercising�
NOTE
• This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment

Explanation of buttons

MODE
- Press MODE button to select console functions; Time, Count,
Distance, RPM & Calorie�
SET
Set the values for: Time, Count, Dist & Calorie when not in scan
mode�
- Press SET button to set console in goal input mode�
- Press MODE to select goal you like to set� (the selected goal will
blink when able to set value�)
- Press SET Button to higher the goal input, hold SET button to
higher the value fast�
- Press RESET button shortly to reset the changed selected goal�
- Press MODE Button to active next optional goal to be set�
Time + 1 min
(1~99)
CNT +10
(1~9990 )
DIST +100
CAL + 1
(1~999 )
RPM
(cannot change)
NOTE
• When you set a goals the set goal value will Count down in
active mode�
• When goal is reached the console will notify by 4 dual acoustic
beep signals� The reached value will now Count up starting from
"0"�
• You can set more than one goal, all goals will notify when goal is
reached�
RESET
- Push and hold for 4 seconds to reset: Time, Calorie & Count�

Extra notes

- If the display is faint or shows no figures, please replace the
batteries�
- The monitor will automatically shut off if there is no signal received
after 4 minutes �
- The monitor will be auto-powered on when starting to exercise
push button w/signal in�
- The monitor will automatically start calculating when you start to
exercise and will stop calculating when you stop exercising for 4
seconds �

Cleaning and maintenance

The equipment does not require special maintenance� The
equipment does not require recalibration when it is assembled, used
and serviced according to the instructions�
WARNING
• Do not use solvents to clean the equipment�
• Clean the equipment with a soft, absorbent cloth after each use�
• Regularly check that all screws and nuts
are tight�
• If necessary, lubricate the joints�

Replacing the batteries (Fig F )

The console is equipped with 2 AAA batteries at the rear of the
console�
To fit/ Replace the batteries
- Remove the cover� (Located on the back side)�
- Remove the old batteries�
Only valid when replacing the batteries for fresh ones�
- Insert the new batteries�
Make sure that batteries match the (+) and (-) polarity markings�
- Mount the cover�
NOTE
• Empty batteries should always be recycled per your Local legal
regulations to save the environment�
WARNING
• Do not expose batteries to big temperature changes to prevent
the batteries from leaking�
• To prevent your batteries from leaking, take them out if you plan
on not using your device for longer periods of time�
• When inserting multiple batteries into a device, always use the
same brand, the same type, and the same energy level�

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment� In most cases, it will
be sufficient to replace the defective part�
- If the equipment does not function properly, immediately contact
the dealer�
- Provide the model number and the serial number of the equipment
to the dealer� State the nature of the problem, conditions of use
and purchase date�

Transport and storage

WARNING
• Carry and move the equipment with at least two persons�
- Move the equipment and carefully put the equipment down� Place
the equipment on a protective base to prevent damage to the floor
surface�
- Move the equipment carefully over uneven surfaces� Do not move
the equipment upstairs using the wheels, but carry the equipment
by the front and rear foot tubes
- Store the equipment in a dry place with as little temperature
variation as possible�
1 7
English

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

20tcfr2050

Inhoudsopgave