Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Some of our products have emergency draining hose and
some does not have. Follow the steps below to discharge the
water.
Discharging the water when the product has an emergency
draining hose:
Pull the emergency draining hose out from its seat Place a
large container at the end of the hose. Drain the water into the
container by pulling out the plug at the end of the hose. When
the container is full, block the inlet of the hose by replacing
the plug. After the container is emptied, repeat the above
procedure to drain the water in the machine completely. When
draining of water is finished, close the end by the plug again
and fix the hose in its place. Turn the pump filter to take it out.
Discharging the water when the product does not have an
emergency draining hose:
Place a large container in front of the filter to catch water
from the filter. Loosen pump filter (anticlockwise) until water
starts to flow. Fill the flowing water into the container you
have placed in front of the filter. Always keep a piece of cloth
handy to absorb any spilled water. When the water inside the
machine is finished, take out the filter completely by turning
it. Clean any residues inside the filter as well as fibers, if any,
around the pump impeller region. Install the filter.
A
If your product has a water jet feature, be sure to fit the
filter into its housing in the pump. Never force the filter
while installing it into its housing. Seat the filter into its
place completely. Otherwise, water may leak from the
filter cap.
If the filter cap is composed of two pieces, close the filter cap
by pressing on the tab. If it is one piece, seat the tabs in the
lower part into their places first, and then press the upper part
to close.
68
EN
Advertenties
Inhoudsopgave
