Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
To prevent flowing of dirty water back into the machine
and to allow for easy discharge, do not immerse the
hose end into the dirty water or drive it in the drain more
than 15 cm. If it is too long, cut it short.
•
The end of the hose should not be bent, it should not be
stepped on and the hose must not be pinched between
the drain and the machine.
•
If the length of the hose is too short, use it by adding
an original extension hose. Length of the hose may
not be longer than 3.2 m. To avoid water leak failures,
the connection between the extension hose and the
drain hose of the product must be fitted well with an
appropriate clamp as not to come off and leak.
Adjusting the feet
A
In order to ensure that the product operates more silent
and vibration-free, it must stand level and balanced on
its feet. Balance the machine by adjusting the feet.
Otherwise, the product may move from its place and
cause crushing and vibration problems.
1.
Loosen the lock nuts on the feet by hand.
2.
Adjust the feet until the product stands level and
balanced.
3.
Tighten all lock nuts again by hand.
A
Do not use any tools to loosen the lock nuts. Otherwise,
they will get damaged.
Electrical connection
Connect the product to a grounded outlet protected by a fuse
complying with the values in the "Technical specifications"
table. Our company shall not be liable for any damages that
will arise when the product is used without grounding in
accordance with the local regulations.
•
Connection must comply with national regulations.
•
Power cable plug must be within easy reach after
installation.
•
The voltage and allowed fuse or breaker protection are
specified in the "Technical specifications" section. If the
current value of the fuse or breaker in the house is less
than 16 Amps, have a qualified electrician install a 16
Amp fuse.
•
The specified voltage must be equal to your mains
voltage.
•
Do not make connections via extension cables or multi-
plugs.
B
Damaged power cables must be replaced by the
Authorized Service Agents.
First use
Before starting to use the product, make sure that all
preparations are made in accordance with the instructions in
sections "Important safety instructions" and "Installation".
To prepare the product for washing laundry, perform first
operation in Drum Cleaning programme. If your machine is
not featured with Drum Cleaning programme, use Cottons-90
programme and select Additional Water or Extra Rinse
auxiliary functions as well. Before starting the programme,
put max. 100 g of powder anti-limescale into the main
wash detergent compartment (compartment nr. II). If the
anti-limescale is in tablet form, put only one tablet into
compartment nr. II. Dry the inside of the bellow with a clean
piece of cloth after the programme has come to an end.
C
Use an anti-limescale suitable for the washing
machines.
C
Some water might have remained in the product due to
the quality control processes in the production. It is not
harmful for the product.
Disposing of packaging material
Packaging materials are dangerous to children. Keep
packaging materials in a safe place away from reach of the
children.
Packaging materials of the product are manufactured from
recyclable materials. Dispose of them properly and sort in
accordance with recycled waste instructions. Do not dispose
of them with normal domestic waste.
Transportation of the product
Unplug the product before transporting it. Remove water drain
and water supply connections. Drain the remaining water in
the product completely; see, "Draining remaining water and
cleaning the pump filter". Install transportation safety bolts in
the reverse order of removal procedure; see, "Removing the
transportation locks".
C
Never move the product without the transportation
safety bolts properly fixed in place!
58
EN
Advertenties
Inhoudsopgave
