Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4
X
• Push the button (Figure 5) to swivel the cable bracket outwards.
• For the purpose of strain relief, put a loop of the extension cord through
the opening in the handle. Push the button (Figure 6) to swivel the
cable bracket inwards again.
• When your work is nished, push the button (Figure 5) to swivel the ca-
ble bracket outwards and pull out the extension cord. Swivel the cable
bracket back into the handle.
6. Switching on / off
6
7. Adjusting the additional handle, the angle of
inclination and the tube length
7
1
8
2
GB | Operating Instructions
5
X
To operate your grass trimmer:
• Make sure you have a secure footing.
• Hold the trimmer rmly (with both
hands).
• Stand upright - hold trimmer in
relaxed position.
• Do not rest the cutting head on the
ground.
• Squeeze the switch 1.
• The trimmer is switched off when
you release the switch.
1. Adjust the front handle : Loosen
the star bolt (Fig. 7) and adjust
the handle to the desired position.
Tighten the star bolt.
2. Adjust the length of the shaft :
(Fig. 8) Loosen the threaded sleeve
(2) by turning it clockwise. Slide the
shaft in/out to the desired length.
Tighten the threaded sleeve (2) by
turning it counter-clockwise.
9
3
10
8. Trimming grass and weeds
11
9. Adjusting nylon line
Check the nylon line regularly if it is damaged or if it still has the correct
length.
12
13
GB-4
3. Adjusting the angle of inclination
(Fig. 9): Pull the button (3) upwards.
Select one of 3 possible angles of
inclination for the motor element. Let
go of the button 3 to lock the motor
element in its position.
The middle position is suitable to
reach under objects as, e.g., bushes
or garden furniture with the trimmer.
The lower position is used for trimming
edges as described in the following
section.
4.
Adjusting the tool for trimming edges
Slide the shaft to its short-
(Fig. 10):
est or longest position as explained
under No. 2
. In this position, the whole
upper part of the handle can be turned
by 180°. Also in connection with this
activity, the tube length can be adjusted
to any positions.
• Sweep trimmer back and forth
uniformly to cut small patches of
grass or weeds. The trimmer is not
con-structed and suitable for cutting
large areas.
• Wherever possible, cut with left-hand
side so that cut-tings, dust and stones
are thrown forwards, away from the
user.
• Ideal working conditions are achieved
if the trimmer is tilted to the left at an
angle approx. of 30°.
When cutting performance deterio-
rates: Hold the running trimmer above
a patch of grass. Tap the cutting head
on the ground. Note the fresh line will
be advanced only if lines are still at
least 2.5 cm (1 inch) long.
If the lines are shorter: Switch off the
trimmer, disconnect plug from power
supply. Press in the spool and pull
end of lines rmly outwards). If end
of lines are not visible - see (re-
placement of spool).
Advertenties
Hoofdstukken
Inhoudsopgave
