Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UK
4.4. Connection with 38-32 mm hose adaptor
Connection with 50 mm pipe
Adjusting the bypass
Use the following procedure to adjust the
bypass:
1. Open Valve 1 & 2 half way.
2. Close valve 2 until control shows
NO Or EE3 screen.
3. Slowly open Valve 2 until pool
Temp shows on screen.
4. If it shows 'ON' or 'EE3' on dis-
play, it means the water flow into
heat pump is not enough, then you
need adjust the valves to increase
the water flow through the heat
pump.
Must not have Valves open Full.
How to get the optimum water flow:
Please turn on the heat pump under
134
MV-1401-1402-1403-1404-10-2021 . © All rights reserved Swim & Fun A/S
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
