Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1. Unplug the appliance and then turn off
the water.
2. Leave the door ajar to prevent the forma-
tion of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location
where the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet
pipe and empty it.
What to do if...
The appliance will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
Fault codes and malfunction
• continuous flashing of the light of the running
programme
• intermittent audible signal
• 1 flash of the end of programme indicator light
The dishwasher does not fill with water
• continuous flashing of the light of the running
programme
• intermittent audible signal
• 2 flashes of the end of programme indicator
light
The dishwasher will not drain
• continuous flashing of the light of the running
programme
• intermittent audible signal
• 3 flashes of the end of programme indicator
light
Anti-flood device is activated
Malfunction
The programme does not start
All manuals and user guides at all-guidesbox.com
Moving the machine
If you have to move the machine (moving
house etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
4. Pull the machine out together with the
Avoid over tilting the machine during trans-
portation.
be solved with the help of the hints described
in the chart, without calling out an engineer.
Switch off the appliance and carry out the
following suggested corrective actions.
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded inlet
hose is blocked.
Clean the filter.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set. If dishes are to be
washed immediately, cancel the delay start.
hoses.
hoses.
Possible cause and solution
Possible cause and solution
75
Advertenties
Hoofdstukken
Inhoudsopgave
