Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
faults
what should I do if...
fault
cause
F0 - Fxx appears.
Button is dirty.
Button is pressed for too
long.
Button is defective.
F99 appears.
Several buttons dirty.
Several buttons pressed for
too long.
E0 appears.
Electronics in oven too hot.
E1 appears.
Thermostat defective.
E2 appears.
Culisensor not connected
correctly.
Culisensor defective.
CU appears.
The culisensor is used with
the wrong function.
CU and 55 flash in turns.
Culisensor is too hot.
GB 24
All manuals and user guides at all-guides.com
solution
Clean the button.
Release the button sooner.
Phone the service
department.
Clean the buttons.
Release the buttons sooner.
Wait until oven has cooled
down.
Phone the service
department.
Insert plug correctly.
Phone the service
department.
Use the culisensor only with
the Turbo, Infra and Infra-
with-fan functions.
Let the culisensor cool down.
The oven is equipped with a so-called DCF clock. The clock
sets itself automatically in response to a radio signal. If the
signal is disturbed it may take longer before the clock sets
itself. This is normal. Should the clock continue to receive
signals badly, reception may be optimised by moving the
aerial.
If there is no
The clock sets itself to Central European Time. You can select
reception the
a so-called offset to this time (the time difference in relation
to Central European Time). You can set a maximum
clock works on
an internal signal.
difference of 1 hour, using the following procedure:
When there is
1
Press the time selector button until the display starts to
reduced
reception, the
blink.
clock will often
2
Release the button and then press the time selector
synchronise itself
button again.
at night.
"OF 0" appears in the display.
3
Set the time difference using the + and - buttons.
"OF-1", "OF 0", "OF 1" appears in the display.
A few seconds after the button is released, the offset is set.
operation
DCF clock
GB 25
Advertenties
Hoofdstukken
Inhoudsopgave
