Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Prior to initial use
Overflow protection
Switching on
Stopping or changing a wash cycle
GB 10
Attention:
• Always fill the salt reservoir and adjust the water hardness setting
before using the dishwasher (see page 12).
• Also fill the rinse agent reservoir and the detergent reservoir (see
page 13, 14 and 15).
Your dishwasher is equipped with a safety device which prevents the
dishwasher from being overfilled with water. The safety device closes
the intake valve and assures that the dishwasher pumps out the excess
of water. When there is water inside the diswasher (because too
much water is pumped in or in case of a leakage), the water has to be
removed before you switch on the dishwasher again.
1. Open the door of the dishwasher.
2. Check if the plug of the connecting cord is in the socket.
3. Check if the water supply is turned on.
4. Load the dishwasher (see page 15: "loading the baskets").
5. Pour in the detergent.
6. Press the On/Off button to switch on the appliance. The indicator will
light up when the machine is switched on.
7. Select the desired cycle (see page 11).
▷ Press repeatedly the washing program selector button to select
the desired washing program. The indicator of the selected
program will light up.
8. Close the door.
9. Press the start button to start the washing.
1. Open the door.
2. Press the start/pause button more than three seconds.
3. Select the desired washing program with the selector button.
4. Close the door.
5. Switch on the appliance with the start/pause button.
Advertenties
Hoofdstukken
Inhoudsopgave
