RESIDUAL RISKS!
■
Even if you operate this power tool properly,
there will still be residual risks. The following
risks can occur in the context of the design
and construction of this power tool:
a) Cuts
b) Hearing damage, if no suitable hearing
protection is worn.
c) Damage to health caused by hand-arm
vibrations if the appliance is used for
extended periods or is not properly used
and maintained.
Original accessories/auxiliary
equipment
■
Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
WARNING!
■
Do not use any accessories which are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
Before initial use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed charger
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient temper-
ature should be between 0°C and 50°C.
│
GB │ IE │ NI
■
10
from or connect
.
♦
Connect the battery pack
charger.
♦
Insert the power plug into the mains power
socket. The red control LED
♦
The green control LED
charging process is complete and the battery
pack
is ready for use.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash simultaneously, this means that the
battery pack
is defective.
♦
Fit the battery pack
Attaching/disconnecting the battery
pack to/from the device
Attaching the battery pack
♦
Allow the battery pack
handle
of the appliance.
Removing the battery pack
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery. The status/
remaining charge will be shown on the battery
display LED
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Fixing/attaching the shoulder strap
♦
Hook the shoulder strap
lug
.
♦
Adjust the length of the shoulder strap
your size so that carrying lug
when hooked in place.
♦
In addition, you can adjust the height of the
carrying lug
on the appliance shaft
loosening the screw.
to the high-speed
will light up.
indicates that the
flashes, this means
has overheated and
back onto the appliance.
to click onto the rear
and remove the
as follows:
into the carrying
is at hip height
PAHE 20-Li D4
to
to
by