Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
E6 comes on.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Installation
Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Assembly
min.
500mm
24
Possible cause
The second phase of the power
supply is missing.
min.
50mm
Check if the hob is correctly connec-
ted to the electrical supply. Remove
the fuse, wait one minute, and insert
the fuse again.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Connection cable
•
The hob is supplied with a connection cable.
•
To replace the damaged mains cable, use the cable
type: H05V2V2-F which withstands a temperature of
90°C or higher. Speak to your local Service Centre.
R 5mm
mm 750
+1
490
min.
55mm
Remedy
+1
mm
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
