Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAQ
■ Drive is not running:
• Check the building fuses and power supply.
• Motor connection completed correctly?
• Remote contol programmed to drive?
• Check batteries in remote contol.
• The drive has overheated and switched off. After approx. 15 - 20 minutes cooling time, the drive is ready for use again.
■ Drive cannot find the end position:
• The drive is not installed. As a result, the limit switch does not turn.
• The adapter ring on the motor that operates the limit switch does not rotate or is not mounted.
■ Drive is buzzing and not running:
• The drive ring at the end of the motor has come loose or has not been attached.
• The motor does not turn because the roller shutter is jammed.
• The motor is not receiving enough power due to a poor power supply.
• Remove locks, handles or stoppers on the roller shutter.
■ The building fuse has tripped:
• Wrong power connection?
• Line damage?
■ The drive is loud:
• Close the roller shutter box.
• Drive has play in axial (shaft) direction. The roller shutter hanging or the shaft bearing is bad and produces the noise. It is necessary
to change the guide rails or attachment to the shaft.
• Wall bearing poor.
■ The drive does not unwind cleanly from the open position:
• The end position OPEN is too high. Set the roller shutter 3-5cm lower.
• The inlet funnel at the top end of the guide rail is missing or bent.
• The final position of the roller shutter has changed upwards, because the blind is winding shorter.
• Guide rails are bad, lubricate if necessary.
DISPOSAL
Our electrical and electronic equipment may not be disposed of with household waste and must be disposed of after use proper-
ly in accordance with WEEE Directive EU: 2012/19/ EU; GB UK(NI): SI 2012 nr. 19 on waste electrical and electronic equipment
in order to ensure that materials are recycled. Collecting waste electrical equipment separately means environmentally-friendly
disposal and is completely free of charge for the consumer.
WEEE reg. no. in Germany: DE66256568.
Any waste packaging left over with the end consumer must be collected separately from mixed waste, in accordance with the
Directive. Packaging may not be disposed of with household waste, organic waste or in nature. Packaging material must be
separated according to its material and disposed of in the recycling containers provided and in certain council recycling bins.
Our batteries are marketed in compliance with the law. The 'crossed-out waste bin' indicates that batteries may not be disposed
of with household waste. Batteries included in the product (technical data). In order to avoid causing harm to the environment
or people's health, used batteries must be returned for regulated disposal at council recycling centres or via retail outlets, as is
prescribed by law. Batteries may only be brought for disposal once fully discharged and, in the case of lithium batteries, with their
terminals taped over. The batteries can be easily removed from our equipment for disposal.
Registration number in Germany: 21002670.
DECLARATION OF CONFORMITY
Hereby, Chamberlain GmbH declares that the equipment type RPD10ER-10, 15, 25, 40 and 041ARTX1 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://doc.chamberlain.de/
28
en
Advertenties
Inhoudsopgave
