Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MASTER REMOTE CONTOL
The master remote contol is the first remote contol that has been taught
on the roller shutter drive. The remote contol with the product RPD10ER,
RPD15ER, RPD25ER and RPD40ER has already been taught as master
remote contol.
If it is necessary to retrain a master hand transmitter, the memory of the
roller shutter drive must be deleted. To do so, the hand transmitters must
first be deleted (see Deleting remote contol).
Programming master remote contol
Perform the following steps to program the master remote contol:
•
Switch off the power supply.
•
Switch on the power supply again. The motor confirms this input by
briefly turning once in one direction.
•
Within 15 seconds, press the red button on the motor once (Fig.
26) , a bleep sounds once.
•
Press the red button for 2 seconds, 8 bleeps follow
Press the learn button on the remote contol (Fig. 27) you want
•
to program within the 8 peep tones. The motor confirms this input
with a short turn once in one direction.
Note the first programmed remote contol. If this is lost, the remote contol
must be deleted (see chapter Deleting remote contol) and then a new
remote contol can be programmed.
PROGRAMMING OTHER REMOTE CONTROL / DELETING REMOTE CONTROL
Other programmed remote contol only serve to operate the shutter: setting
or changing the end positions is only possible with the master hand remote
contol.
Programming another remote contol
Press the learn button on the master remote contol (Fig. 28) or the already
programmed remote contol 8 x (motor bleep) and then press the learn key
of the new remote contol. The motor confirms this with a short jerk in each
direction. New remote contol has been successfully programmed.
Deleting all hand-held remote contol
To delete hand-held remote contol, the following steps must be performed:
• Switch off the power supply.
• Switch on the power supply again. The motor confirms this input by
briefly turning once in one direction.
• Press the red button on the motor 5 x 5 bleeps.
• Then hold down the red button again for approx. 2 seconds. The
motor confirms this input by briefly turning once in one direction.
All remote contol successfully deleted.
Fig. 26
Fig. 29
26
Red Button
╬
Fig. 27
╬
Fig. 28
Red Button
en
Advertenties
Inhoudsopgave
