Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
SETTING OPERATING MODES
The RPD10ER, RPD15ER, RPD25ER and RPD40ER drives have the
following operating modes (factory setting is Mode 1).
1. Mode 1 End positions, Reversing completely on detecting an
obstacle in the OPEN position.
Settings Mode 1:
•
Press the OPEN and CLOSE button on the handheld trans-
mitter simultaneously
•
Then press the Stop button 2 x
•
Now press the OPEN and CLOSE button simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 1 is now set (End positions, reversing completely to the OPEN
position when an obstacle is detected ).
2. Mode 2 End positions, reversing to OPEN position on detection of
obstacle for 2 seconds.
Settings Mode 2:
•
Press the OPEN and CLOSE button simultaneously
Then press the Stop button 4 x
•
•
Now press the OPEN and CLOSE button simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 2 is now set (End positions, reversing on detecting an obsta-
cle for 2 seconds in OPEN position ).
3. Mode 3 End positions, stop on detecting an obstacle.
Settings Mode 3:
•
Press the OPEN and CLOSE button simultaneously
•
Then press the Stop button 3 x
•
Now press the OPEN and CLOSE button simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 3 is now set (End positions, obstacle detection stop ).
4. Mode 4 Only end positions (no obstacle detection).
Settings Mode 4:
•
Press the OPEN and CLOSE button simultaneously
•
Then press the Stop button 6 x
•
Now press the OPEN and CLOSE button simultaneously
again. The motor acknowledges this entry with a short turn
once in one direction.
Mode 4 is now set (End positions only, no obstacle detection ).
}
1 x
}
1 x
}
1 x
}
1 x
27
2 x
}
1 x
4x
}
1 x
3x
}
1 x
6 x
}
1 x
en
Advertenties
Inhoudsopgave
