Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3 Assembly
Before attempting assembly, read the safety information in Section 2.
3.1 Checking the items supplied
Carefully open the cardboard packaging.
•
In doing so, do not use any long knife blades. They may damage the components inside.
•
Check the parts supplied against the list in Section 1.4 Items supplied.
•
Check the contents for visible transit damage, paying particular attention to the electrical wiring.
•
In the event of any damage or incorrect components, contact customer services (see Section 6).
Do not attempt to assemble the workstation frame if there is any damage or if there are any in-
•
correct components.
3.2 Packaging
Remove the packaging. Treat as household waste/paper.
•
Observe national legislation.
•
3.3 Tightening torques for screws used
Assemble the workstation frame with the tools supplied only.
•
3.4 Assembly of the workstation
3.4.1 Pre-assembly of the Crossbar
Assemble the following components:
#
Part name
06
Crossbar
09
Allen key M3
10.1 Set Screw M6x6
Set screw M6x6
Assemble the 2 set screws in the tapped holes.
•
Do not yet tighten the socket screws!
Tighten the socket screws only after assembling the components in step 3.4.7 Adjustment
•
of the frame width, page 17.
Indicative:
Qty
Frame set-up
1
1,1 m
1
1,3 m
1,5 m
2
1,7 m
Wide/size tabletop
120 cm
140 cm
160 cm
180 cm
7
Advertenties
Hoofdstukken
Inhoudsopgave
