Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
English
= Factory settings reset.
= Factory settings not reset
3- Press the key
for 5 seconds. The device returns to its initial
configuration and goes back automatically to Auto mode.
The following factory values will be effective:
Settings
Comfort setting temperature
Boost duration
Keypad lock
User settings
Backlighting
Eco mode temperature lowering level
Frost protection temperature
Minimum set of Comfort setting
temperature
Maximum set of Comfort setting
temperature
Maximal Boost duration
Maximum ambient temperature
for the automatic stop of the Boost
Temperature unit
Installer settings
Automatic open window
detection
PIN code protection
Value of the PIN code
Expert settings
Power
Indoor temperature monitoring
To exit the expert settings, press
15.Fitting and connections
15.1 Assembling of the controller on to the towel rails
Important: Before carrying out any connection tasks, cut off the power
supply to the electronic regulator using the circuit breaker or the protection
fuse in the power supply circuit
Connection tasks must be carried out by a qualified professional installer.
• Assembling of the controller on to the towel rails
1- Fitting the joint to the cartridge heater (the cartridge)
5 sec.
Factory settings
Operation
19°C
60 min.
Disabled
L3
-3,5°C
7°C
7°C
30°C
60 min.
39°C
°C
Enabled
Disabled
0000
500W
90°C
3 times.
Fit the joint (supplied) onto the cartridge heater to ensure that the latter
fits snugly into the electronic regulator:
Another
o-ring,
may
be present on the cartrid-
ge at this location, depen-
ding on the manufacturer.
It will in no way hinder
assembly of the product.
Leave
it
in
place.
However,
despite
the
presence of o-ring you
still have to put o-rin-
g(supplied)
in
place.
2- Connecting the electronic regulator to the cartridge heater.
Bring the electronic regulator close to the cartridge heater, in order to connect
the two insulated female Faston lugs (the output contacts) to the two male lugs
on the cartridge. Press the lugs together firmly.
3- Fitting the electronic regulator to the cartridge heater
Fit the regulator to the base of the cartridge heater.
4- Fitting and tightening the electronic regulator onto the cartridge heater.
Keep the electronic regulator (B) pressed onto the base by exerting an
upwards force (and thus ensuring that joint is compressed (C) when you are
screwing in the cone-point set screw to the back of the product using an allen
key (A).
Tightening torque required: 0,5N.m.
- 36 -
Bottom of the towel rails
Existing o-ring
Supplied o'ring
Cod. 1910000000276 - nv01
Advertenties
Hoofdstukken
Inhoudsopgave
