Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
and / or removed. The guarantee shall be effective after examination of
the defects and their relevant causes. The material to replace or repair
must be delivered at the retailer warehouse . The obligation to provide
the guarantee is subject to the conditions and requirements set out below.
The radiator has not been damaged during shipping, handling or
installation and any repairs and / or modifications has been carried out
by a third party, if not expressively authorized by the manufacturer . The
material has been stored in good condition and protected from the weather
before being installed. The installation of this product should be performed
by qualified personnel and in accordance with these instructions and all
safety equipment rules both national and local . Do not place the radiators
in rooms with the presence of chlorine vapours or corrosive fumes such as
swimming pools saunas, spa tubs
6. Instructions for installation in Bathroom
The national rules on installing electrical equipment in the bathroom
must be scrupulously respected. The electric radiators must be always
installed outside zone 1 and 2.
The electric switch and control elements most be mandatory located in
zone 3, in order that no electrical control center is accessible to anyone
using the shower or bath.
AREA 1
AREA 2
AREA 3
Install the radiator in such a way that the minimum distance between
the floor and the thermostat is 250mm and make sure that there are no
obstacles within a minimum distance of 100mm from the appliance.
7. Wall mounting
The electric radiaotrsmust be mounted on the wall following the
instructions provided in the packaging of fastening supports.
When the radiator is in the proper position, the resistor is located at the
bottom right. The radiator must absolutely never be installed with the
resistor turned upwards or in any direction other than pointing downwards,
as the heating element in the resistor itself would be irreversibly damaged
during operation. Never position the radiator in front of the power socket.
Make sure that the resistor never operates unless it is fully submerged.
YES
YES
Cod. 1910000000276 - nv01
Z O N E 0
NO
NO
NO
8. Connecting up
All models of Cordivari electric radiator are fitted with a power cable
complete with a pre-mounted Shuko plug. Before connecting up, make
sure that the rated voltage of the appliance (230V) corresponds with the
mains voltage, and also check to ensure that the wall socket is properly
earthed in compliance with current regulations and that it is capable of
delivering the rated current required to operate the chosen model at full
power.
9. Cautions
When operating normally the radiaotr has very hot surface. It is normal
for the bottom pipes not to heat up. Only warm towel that has been
washed in water. The resistors on electric radiators must never operate
without filling fluid, and for this reason the connections on the radiator
itself must never be opened.
In the event of accidental overheating and/or improper use, the resisitor
circuit may cut out. In this event the resistor can no longer be used, and
must be replaced.
10.Replacing of electrical immersion
Should it be necessary to replace the resistor, this must be
done exclusively by the manufacturer, by a person with suitable
qualifications, so as to avoid any risks.
11. Operation
11.1 Scheme
• Buttons overview
1
2
1. Infrared receiver
2. Button power on/standby mode
3. Selecting operating modes.
4. Plus and minus buttons, used to set temperatures, time, date and pro-
grammes.
5. Save settings
6. Boost
- 23 -
2
3
5
4
English
6
Advertenties
Hoofdstukken
Inhoudsopgave
