Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Automatic activation (factory settings)
The device detects a temperature fall. An opened window, a door to the
outside, can cause this temperature fall.
Note: The difference between the air from the inside and the outside
must cause a significant temperature fall to be perceptible by the device.
This temperature drop detection triggers the change to Frost Protection
mode.
• Manual activation
By pressing
for more than 5 seconds, the device will switch on Frost
protection mode.
• Frost protection digital meter
When the device performs a lower temperature cycle due to opened
window, a meter appears on the display to show he cycle time. The
counter is automatically reset the next time Frost protection by opened
window is activated (automatic or manual activation).
• Stop the Frost protection mode
By pressing any button, you stop the Frost protection mode.
Note: If a temperature rise is detected, the device may return to the
previous mode (active mode before the open window detection).
11.11 Optional: Remotely management by infrared remote control
Your towel rails can be managed by a remote control with infrared transmission
through its IR receiver located on the front of the controller.
12.User settings
12.1 Access
Access to the User settings in 3 steps:
From Auto, Comfort, Eco or Frost protection mode:
Information
1
display
Press for 5
1
seconds
Setting sequence :
Backlighting → Eco mode temperature lowering-level → Frost protezione
temperature → Comfort setting temperature limits → Maximal Boost duration
→ Maximum ambient temperature → Temperature unit
Cod. 1910000000276 - nv01
5 sec.
2
Press twice
- 29 -
• Scheme
Display of the ambient temperature
Boost
Selection of the Auto, Comfort, Eco, Frost
protection modes
Adjustment of the setting temperature
desired and the boost duration
Note: the buttons
,
buttons on the controller.
• Operation
Position the remote control toward the infrared receiving window of the
device. Check that there is no obstacle between the remote control and
the infrared receiver to disturb the transmission.
Information
display
1
12.2 Backlight setting
1- Three modes can be set:
= Temporary backlighting: Backlight of the display when a button is pressed
= Non-stop backlighting: Backlight of the display all the time
= In this version, the device will work according to the L1 mode.
English
,
and
have the same features as the
2
= User settings
3
Press briefly
Infrared
receiving
window
Advertenties
Hoofdstukken
Inhoudsopgave
