Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Printing Is Too Light or Too Dark
in All Colors
Transparency Print Quality
Possible Print Quality defects occurring on
Transparency media such as:
Light and/or Dark spots
Smeared Toner
Light Bands on print
See www.xerox.com/officeprinting/infoSMART on the world wide web for more on-line support information.
Page 3 of 3
Solution
1. Try a different Color Matching mode. From the printer's front
panel
Support Menu
select
Print-Quality Tips
Note:
The TekColor Correction set to Automatic provides the
best results for most documents.
2. If the print is too light, verify that the printer driver Print
Quality Mode or Front Panel Defaults is not set to Draft
Mode.
3. Adjust the light or darkness levels. From the front panel
Support Menu
select
Calibrate Colors
Menu, then selet
the procedure for
Lighten/Darken Colors.
Use only Phaser
6200 Transparency.
®
Using non-Phaser
6200 Transparencies may cause print-
®
quality problems or damage the printer's Fuser.
Damage caused by using non-supported media will not be
covered under the warranty, service agreement or Total
Satisfaction Guarantee.
For a list of Transparency part numbers, refer to the printer's
Paper Tips
Page.
select
Improve Print
Quality?, then
Page. and press OK.
Improve Print
Quality?, then select
Print Tutorial
Page. Follow
Advertenties
Inhoudsopgave
