Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Emptying the Dust Container
1. Remove the dust container from the
motor unit (F) (see the "Assembly"
chapter – "Removing / Inserting the
Dust Container").
2. Hold the dust container over an open
dustbin. The distance from the dust-
bin should be as small as possible so
that the dust does not spread in the
surrounding air.
3. Pull the tab (2) on the dust container
gently upwards. The lid of the dust
container (1) will open and the dirt
will fall out.
4. To close it, press the lid onto the
dust container. The tab must engage
audibly.
Cleaning the Dust Container, HEPA
Filter, Dust Filter and Filter Holder
1. Pull out the HEPA fi lter (5) by the
handle.
2. Reach into the dust container and
pull out the dust fi lter (4) with the
fi lter holder (3).
3. Twist the dust fi lter anticlockwise and
pull it out of the fi lter holder (Picture
D1).
4. Tap out all parts and clean them with
a soft brush if necessary.
5. The fi lter holder and dust fi lter can
also be rinsed with clear water.
NOTICE: Do not wet-clean the HEPA
fi lter!
6. Wipe out the dust container with a
damp cloth if necessary.
Let all parts dry completely in the air
before you reassemble them.
NOTICE: Never assemble wet or
damp components or attach them to
the motor unit (F)!
Assembly
1. Insert the dust fi lter into the fi lter
holder and twist it clockwise until it
fi ts securely (Picture D2).
18
09234_Inlay_DE-EN-FR-NL_A5_V2.indb 18
09234_Inlay_DE-EN-FR-NL_A5_V2.indb 18
2. Insert the fi lter holder with dust fi lter
into the dust container so that the
two recesses fi t directly above one
another (Picture E). The fi lter holder
must fi t correctly in the dust contai-
ner, it must not stick out at the top.
3. Place the HEPA fi lter on top of the
dust fi lter.
4. Insert the dust container back into
the motor unit (see the "Assembly"
chapter – "Removing / Inserting the
Dust Container").
Cleaning the Motor Unit, Extension
Tube and Nozzles
•
Wipe down the motor unit (F), ex-
tension tube (G) and nozzles with a
damp, soft cloth if necessary. Then
dry with a soft cloth.
•
Regularly remove hair and fl uff from
the nozzles and brushes.
Cleaning the Electric Floor Nozzle
To make it easier to clean, the brush
can be removed from the electric fl oor
nozzle (I):
1. Slide the latch fastener on the
bottom of the electric fl oor nozzle to-
wards the small wheel on the electric
fl oor nozzle (Picture F1).
2. Open the latch and remove (Picture
F2).
3. Take out the brush and remove any
contamination.
4. Reinsert the brush. When you do
this, fi rst insert the end with the star-
shaped recess.
5. Insert the latch and slide the latch
fastener back in place.
Storage
•
Store the device in a cool, dry place
which is protected from direct
sunlight and is out of the reach of
children and animals.
•
For easy storage and to save space,
the brush nozzle (B) and crevice nozz-
21.09.2020 17:20:25
21.09.2020 17:20:25
Advertenties
Hoofdstukken
Inhoudsopgave
