Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB/IE/NI
4. Now, insert the adapter
2a
into the ball.
If you are finished with pumping, flip the lever
wards and remove the pump head
3
from the valve.
8. Using the pump
1. Put the pump head
3
on the valve, see 7. Pur-
poses of the pump head and the adapt-
ers (fig. C1).
2. (fig. B1) Place the product
1
on a sturdy and
level surface.
3. (fig. B2) Always stand on the with both feet on
the treat
4
of the product
1
while pumping, so
that it is secured against tipping over.
4. (fig. B3) Activate the pump handle
5
and not too quickly.
NOTE!
-
(fig. B4) The pump hose
6
must not be
kinked.
-
(fig. B5) In the middle of the pressure gauge
is a red indicator
8
. This red indicator
8
can be
used as a visible mark for the desired air pressure.
To do this, turn the red indicator
8
to the desired
pressure display.
Please note that the set mark is only for orienta-
tion and does not influence the air pressure!
NOTE!
To transport the product
1
, place the pump hose
6
over the pump handle
5
as shown in Fig. A1.
Clamp the pump hose
6
into both of the clamping
devices
9
, as shown.
Connect the pump hose
6
to the cnnection clip
as shown in Fig. A1.
Now, you can lift the product
1
on the pump handle
5
.
9. Cleaning & care instructions
-
clean with a damp cloth
-
do not immerse in water
-
Check the screw fittings of the product
1
for tight-
ness prior to use
-
The product
1
is maintenance-free.
-
Store the product
1
in a cool, dry place, protect-
ed from UV light.
10. Disposal
Disposal of the packaging
The packaging and instruc-
07
tions are made of environ-
O
mentally friendly materials
8
that you can dispose of at local recycling points.
3a
up-
Disposal of the product
The product can be disposed of with normal house-
hold waste.
11. Warranty
Dear customer, the warranty on this product is 3
years from the purchase date. In the event of defects
in this product, you are entitled to exercise your stat-
utory rights against the seller of the product. These
statutory rights are not limited by our warranty de-
scribed in the following.
evenly
Warranty conditions
The warranty begins on the date of purchase. Please
keep the original receipt. This document is required
as verification of the purchase.
If a material or manufacturing defect arises within
three years from the purchase date of this product,
7
the product will be repaired or replaced, as per our
choice, at no charge to you. This warranty service re-
quires the submission of the purchase receipt and the
defective product within the three-year period and
a short written description of the defect and when
it arose.
If the defect is covered by our warranty, the repaired
or a new product will be returned to you. The war-
ranty period does not restart with the repair or re-
placement of the product.
Guarantee period and statutory claims for
defects
The guarantee period will not be extended by the
10
warranty. This also applies to replaced and repaired
parts. Damage and defects which may possibly al-
ready exist upon purchase must be reported imme-
diately after unpacking. After the guarantee period
has expired, required repairs shall be subject to a
charge.
Scope of guarantee
The device has been carefully produced under strict
quality guidelines and conscientiously inspected pri-
or to delivery. The guarantee service applies to ma-
terial or manufacturing faults. This guarantee does
not extend to product parts, which are exposed to
normal wear and tear and can therefore be regard-
ed as wearing parts or to damage to fragile parts,
e.g. switches or which are made of glass.
This guarantee shall lapse, if the product is damages,
not used properly or maintained properly. For prop-
er use of the product, all of the instructions in the op-
erating instructions must be precisely complied with.
Purposes and actions, which are dissuaded from or
warned about in the operating instructions must be
avoided.
The product is only intended for private and not
commercial use. In the case of abusive and improper
handling, use of force and with interventions, which
are not performed by our authorised service branch,
the guarantee shall lapse.
Processing in the case of a guarantee claim
To ensure quick processing of your concern, please
follow the instructions below:
-
Please have the till receipt and article number
available (IAN 436312_2304) as proof of the
purchase.
-
You can find the article number on the rating plate
on the product, as an engraving on the product,
the title place of your instructions or the sticker on
the back or underside of the product.
-
If malfunctions or other defects occur, first contact
the service department below by telephone or
e-mail.
-
You can then send a product that has been re-
corded as being defective, including the proof of
purchase (till receipt) and stating what the defect
is and when it occurred, postage-free to the ser-
vice address provided to you.
On www.lidl-service.com, you can download these
and many other manuals, product videos and instal-
lation software.
With this QR code, you can directly
reach the Lidl Service website (www.
lidl-service.com) and can open your
operating instructions by entering the
article number (IAN 436312_2304).
12. Distributor
MONZ Handelsgesellschaft
International mbH & Co. KG
Schöndorfer Str. 60–62
DE-54292 Trier/GERMANY
13. Service address
MONZ SERVICE-CENTER
c/o Teknihall Elektronik GmbH
Alfred-Nobel-Str. 1
DE-63128 Dietzenbach/GERMANY
Hotline: 00800 / 68546854 (free of charge,
GB/IE/NI
mobile networks may vary)
E-Mail: monz-gb@teknihall.com
E-Mail: monz-ie@teknihall.com
E-Mail: monz-ni@teknihall.com
10/2023 / PO30030330
Monz item no.: 26241
IAN 436312_2304
9
Advertenties
Inhoudsopgave
