Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
recommended to carry out the work with
an additional person.
Push the flux cored wire through the wire
„
31
feed guide
(see Fig. M).
Guide the wire along the feed roll
„
and push it into the cable assembly
32
holder
(see Fig. N).
Swivel the thrust roller unit
„
the feed roll
19
Mount the adjustment
„
O).
Set the counter pressure with the
„
adjustment screw. The welding wire must
be firmly positioned between the thrust
roller and feed roll
without being crushed (see Fig. O).
Switch on the welder on the main
„
switch.
Press the torch button
„
Now the wire feed system pushes the
„
welding wire through the cable assembly
12
and the torch
As soon as 1 – 2 cm of the wire pro-
„
trudes from the torch neck
11
torch
button again (see Fig. P).
Switch off the welder on the main switch.
„
Screw the welding nozzle
„
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. Q). When using the
delivered welding wire (Ø 0.9 mm), the
welding nozzle
0.9 mm must be used.
Screw the burner nozzle
„
the torch neck
33
Always unplug the mains
plug from the socket prior to each mainte-
nance task or preparatory work in order to
prevent the risk of an electric shock, injury or
damage.
z Using the device
z Switching the device on
and off
18
GB/IE/NI
28
towards
(see Fig. O).
27
screw (see Fig.
in the upper guide
19
11
.
10
.
33
, release the
15
back on.
15
with the labelling
back onto
9
(see Fig. R).
Switch the welder on and off on the main
„
5
switch. If you do not intend to use the
welder for an extended period, remove
the plug from the power socket. This is
the only way to completely de-energise
the device.
19
z Setting the welding current
and wire feed
The control dial
can be used to adjust the material thickness
to be welded. Power and wire feed are
controlled automatically.
Recommended welding wire diameter for the
5
material thickness given
Welding wire
diameter
0.6 mm
0.8 mm
0.9 mm
1.0 mm
15
The following table shows the welding
current range, depending on the setting
selected for the material thickness:
Material thickness
setting
0.8 mm
1.5 mm
2 mm
2.5 mm
3 mm
on the front of the welder
7
Thickness of the
workpiece
0.8–1.5 mm
0.8–2.0 mm
0.8–3.0 mm
1.0–3.0 mm
Welding current
range
20-45 A
45-60 A
75-90 A
90-110 A
110-120 A
Advertenties
Hoofdstukken
Inhoudsopgave
