Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9. GETTING STARTED
Connect mains adapter (only HygroCube 100)
The VOC sensor of the HygroCube 100 functions fully only with the wall plug transformer enclosed. Plug the
wall plug transformer's low-voltage plug into the socket (15) located on the side of the measuring device. Con-
nect the wall plug transformer to a socket connected to the national grid.
When the external power supply (mains adapter) to the HygroCube is disconnected, the features
are reduced to those of the HygroCube 55.
Initial calibration and warm-up phase (only HygroCube 100)
The warm-up phase for the VOC sensor lasts about 15 min. at an ambient temperature of 22 °C. H-UP is
indicated on the display during this time.
In the fi rst 72 hours, the air quality sensor adapts automatically to all of the ambient conditions and thus, can
deliver out-of-spec values.
Discrepancies continuing to occur even after this period may be remedied by changing the position
of the HygroCube.
10. DATE, TIME AND ALARM SETTING
The device switches automatically to the "Set" mode as soon as the batteries were inserted. Alternately, press
the SET button (11) for about 3 seconds to enter the "Set" mode.
The value to be set fl ashes and can be changed by pressing the buttons "+" (12) and "-" (13).
Press the SET button (11) once again to reach the next setting point.
Following values can be adjusted in the "Set" mode:
• Time
• Date / year
• Alarm value for mould indicator
• Alarm value for VOC (only for HygroCube 100)
22
Advertenties
Hoofdstukken
Inhoudsopgave
