Download Inhoudsopgave Inhoud Print deze pagina

Chemical Dosing System; Pre-Cleaning Advice - Numatic TTV-4555/100T Bedieningshandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

!
When handling and mixing chemicals.
Always ensure that chemical manufacturer's safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-driers.

Chemical dosing System

The TTV-4555 scrubber dryer has an optional automatic chemical-dosing system.
Simply fill the 5 litre chemical dosing bottle and the machine will deliver the correct mix ratio as set by the operator,
using the setting on the control panel (see page 20) depending on the floor and cleaning conditions.
Fig.23
To fill the chemical-dosing bottle, first make sure the top waste tank is fully drained then, lift up the waste-water tank
(Fig.23), unscrew the bottle cap then remove the dosing bottle, (Fig.24) and fill with appropriate cleaning chemical.
Refit dosing bottle (Fig.25) and replace bottle cap 38mm / 42mm (Fig 25a), and carefully lower waste-water tank.
After use, ensure the chemical dosing tank is emptied, cleaned and refilled with clean water.
The dosing pipes also need to be cleaned and flushed through with clean water for at least 60 seconds after use.
Note: always ensure that the waste-water tank is empty before lifting.
!
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place-out appropriate warning signs and sweep or dust-mop the floor
Fig.24
18
Fig.25
Fig.25a
!
!

Advertenties

Inhoudsopgave
loading

Inhoudsopgave