Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4
Operating instructions
WARNING: Risk of electrocution. High-voltage circuits, both AC
and DC, are very dangerous and should be measured with great
care.
1. ALWAYS turn the function switch to the OFF position when the meter is
not in use
2. If "OL" appears in the display during a measurement, the value exceeds
the range you have selected. Change to a higher range
4.1
DC voltage measurements
CAUTION: Do not measure DC voltages if a motor on the circuit is
being switched ON or OFF. Large voltage surges may occur that
can damage the meter.
1.
Set the function switch to the green
VDC position
2.
Insert the black test lead banana plug
Into the negative COM jack
3.
Insert the red test lead banana plug
into the positive V jack
4.
Touch the black test probe tip to the
negative side of the circuit
5.
Touch the red test probe tip to the
positive side of the circuit
6.
Read the voltage in the display
39
www.nieaf-smitt.com
Advertenties
Hoofdstukken
Inhoudsopgave
