Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Use
Switching the product
1. Switch the ON/OFF switch
the product on. The product will automatically switch on or
off at twilight and charge the battery at daylight.
2. Switch the ON/OFF switch
switch the product off.
Replacing the rechargeable battery
(see Fig. C)
The rechargeable battery should be replaced every 12 months
to ensure optimum performance.
Note: For this step, you will need a cross head screwdriver
(not included).
For model A:
1. Turn the product over and hold it tight. Switch the ON/OFF
switch
to position "OFF" to switch off the product. Loosen
4
the fastening screws
and then lever out the battery compartment lid
help of a slot screwdriver.
2. Take out the silicone cover
able battery to a new one, ensure that you do not damage
the wiring. Take care to the correct polarity, when inserting
the new rechargeable battery. The polarity is indicated in
the battery compartment
has to have the same technical data like the old one (refer-
ence to "Technical data").
3. Put back the silicone cover
cover
, otherwise the IP protection is not guaranteed. Now
9
again fasten the battery compartment lid
tening screws
Switch the ON/OFF switch
the product switching on during darkness.
For Model B and C:
1. Remove the solar panel housing
attachment
2. Switch the product off by means of the ON/OFF switch
before removing or inserting the rechargeable battery
3. Open the rechargeable battery cover
the solar panel housing
screws
anti-clockwise using a cross head screwdriver.
7
by using a small cross head screwdriver
7
10
9
by using a small cross head screwdriver.
7
.
2
. To do so, unscrew all fastening
1
in the ON position to switch
4
in the OFF position again to
4
. Exchange the old recharge-
9
. The new rechargeable battery
. Pay attention to the silicone
8
to position "ON" to enable
4
from the ground spike
1
on the bottom of
8
with the
8
, fasten the fas-
4
.
6
GB/IE/NI
13
Advertenties
Hoofdstukken
Inhoudsopgave
