Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Pull the rear end of the shelf support
away from the side wall and remove it.
1
2
4. Install the shelf supports in the opposite
sequence.
11.3 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Make sure the appliance is cold
2. Fully open the door.
3. Press the clamping levers
door hinges.
A
4. Close the oven door to the first opening
position (at approximate angle: 70°).
5. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
6. Put the door with the outer side down on
a soft cloth on a stable surface.
7. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
28
ENGLISH
on the two
A
on the top edge of
2
B
8. Pull the door trim to the front to remove it.
9. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
10. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
11.4 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
