Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Press and hold < / > or
alarm. The
and
display will show the current time after
approximately 7 seconds.
Delayed timed operation
In order to set the appliance to switch off at a
specific time after a set Duration has elapsed,
set the Duration and the End Time:
repeatedly until the display
Press
OK
shows dur (duration) briefly and the
symbol will be flashing,
set the desired Duration using the < / >
button as for timed operation.
Press
repeatedly until the display
OK
shows End briefly and the
be flashing,
set the End Time using the < / > buttons
to a maximum of 23 hours and 59 minutes
ahead,
set the function selector knob and the
temperature selector knob to preferred
settings. The
active. The appliance will switch on at
End Time minus Duration (i.e. if the set
Duration is 1 hour and the set End Time
is 14:00, the appliance will automatically
switch on at 13:00).
Once the Duration time has elapsed the oven
will turn off automatically. You will hear an
alarm and the
and
Set the oven function selector knob and
the temperature selector knob in off posi-
tion,
Press and hold < / > or
alarm. The
and
display will show the current time after
approximately 7 seconds.
Cancel settings
Timer and delayed timed function settings
may be cancelled at any time.
Cancel the delayed timed function settings:
Press and hold the < / > button simultane-
ously,
to mute the
OK
will be off and the
symbol will
and
functions are now
will be flashing,
to mute the
OK
will be off , and the
Cancel Minute Minder settings:
press the
OK
minder,
press the < / > buttons
Change the beep tone
You can change the beep tones as follows:
Press and hold the < / > button simultane-
ously,
to select tone, and the display
press
OK
will flash:
press < / > to select the desired tone:
use the > button to select tones 1 to 3
use the < button to select tones 3 to 1.
Adjust display brightness
You can adjust display brightness 1 to 9,
where 1 is the darkest and 9 is the brightest.
The brightness setting applies to an inactive
control panel, i.e. when none of controls are
used 7 seconds.
You can adjust display brightness as follows:
simultaneously press the < / > buttons
repeatedly to select the bri
press
OK
(brightness) setting — the settings can
be accessed in sequence ton (tone) and
bri (brightness).
use the < / > buttons to select the desired
brightness
use the > button to select tones 1 to 9
use the < button to select tones 9 to 1.
Note:
The display is at its brightest setting when
active, i.e. a control was touched within the
last 7 seconds.
Night Mode
The display is dimmed during the night hours
22:00 — 06:00.
21
button to select the minute
Advertenties
Hoofdstukken
Inhoudsopgave
