Inhoudsopgave
Advertenties
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the
floor tool gets snagged, whilst in transit.
Note: The lever moves upward and backward motion to lock the floortool in the raised position.
Note: It is easier to fit the floor-tool if the weight of the machine is resting on the brush.
9
Filling the clean-water tank
10
Note: Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc)
Machine Set-Up
The floor tool carrier can be raised
and locked from moving by operat-
ing the locking lever, upwards and
backwards.
This lever can be found next to the
lower section of the handle.
Unlock and swing the floor tool car-
rier to the side of the machine
(Fig 8).
Ensure the brush is fitted first.
Secure to the carrier using the two
knobs fitted to the floor tool carrier
(Fig 9) - (Fig 9a).
Do not over tighten the retaining
knobs.
The HT1840 TT1840 is equipped
with a large 18 litre clean water tank
allowing large areas to be cleaning in
a single fill.
To fill the clean water tank, remove
the filler cap (Fig 10).
Fill using a hose, bucket or a suitable
container. (Fig 11).
are not allowed to enter the clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
8
9a
11
8
Advertenties
Inhoudsopgave
