4.
Installation
•
Make sure that the hoses for the liquids are correctly connected.
•
Do not cut or kink the hoses.
•
Only use the supplied materials to install the system. Only use the power adapter supplied
with the system.
•
Use only genuine replacement parts and accessories. The use of other parts will invalidate
the warranty and CE marking and may result in personal injury.
•
Avoid damage from defective power supply cables. In the case of damage, the plug-in power
supply must be replaced by the manufacturer or his customer service or an equally qualified
person.
•
The enclosed plug-in power supply (plug type C) is only suitable for use with Schuko sockets
(CEE 7/4).
•
The miscea systems are only suitable for indoor use.
•
Do not install if the product (power cord) is live.
•
Make sure the surface on which the system is installed is strong enough to support the
weight of the unit.
•
Do not scratch, damage, manipulate, bend, twist or bundle the power cord, or place heavy
objects on it or pinch it.
•
Do not disassemble or modify the unit, which is not specifically described in this manual. This
could result in fire, electric shock or injury.
•
Do not use the system in a hot place, such as a shower where condensation may form on the
appliance, or where water may spatter directly onto the appliance. This could result in fire,
electric shock, or a malfunction.
•
Use single-phase power with 220-240V.
•
The miscea CLASSIC system components must be protected against mechanical damages,
like heat and direct sunlight (maximum temperature is 50 degrees Celsius). Do not place
near heat sources or open fire. Do not install the product in locations where salt damage may
occur or where aggressive, neutral or reductive gases are present.
CAUTION
Care must be taken that the system components are easily accessible for maintenance work.
•
The screen seals that are fitted to the valve must be installed in order to prevent dirt from the
pipeline.
•
Open cold and hot water supply and check connections for leaks.
4.1
Installing the system
CAUTION
•
Flush the water supply system thoroughly before installing the system (Observe DIN 1988 /
DIN EN 806!). Be sure that the water supply is absolutely clean. Dirt and debris in the water
can impair the function and / or damage the functional parts of the electrical appliance,
miscea is not responsible for damages of this nature.
•
Install a shut-off valve between the water supply and the system. In case of maintenance or
repair work to the system, the shut-off valve can be closed and it will not be necessary to shut
off the water supply system.
•
Refer to fig. D - I for the installation of the system. Assemble the system in the given order.
22