Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
B
Using the appliance
Recommendations for installation of the evacuation duct
The following rules must be strictly followed, in order to obtain optimal air extraction:
• Keep the evacuation duct short and straight.
• Do not shorten or obstruct the evacuation duct.
• If you use a flexible pipe, always install it so that it is properly stretched out to limit pressure losses.
• Failure to comply with these basic instructions will reduce the performance of the hood and
increase its noise level.
• All installation work must be carried out by a qualified electrician or a competent person.
• Do not connect all the ducts in the hood to an existing ventilation system that is used for another
device, such as heating, gas or hot air ducts. The angle of curvature of the ventilation duct shall not
be less than 120º; you need to position the duct horizontally. Otherwise, raise the pipe vertically
from the entry point and guide it towards an outside wall.
• Once the installation is complete, check that the extractor hood is level to avoid any accumulation
of grease on one end.
Ensure that the evacuation duct chosen for the installation meets applicable standards and is
flame retardant.
Correct
WARNING :
For safety reasons, please only use fastening or mounting screws with
the dimensions recommended in this user manual. Any non-compliant installation of the
screws or fastening devices with these instructions presents an electrical hazard.
14
Incorrect
EN
B
Using the appliance
Using your extractor hood
LED touch control
The LED touch control has five buttons, see figure.
Reduce
Increase
Lamp
Timer
On/Off
1. Turning on the appliance: once the extractor hood has been connected to the main power supply,
the backlighting of all the buttons will come on. The LED display comes off. The extractor hood
does not work, it goes into standby mode. The backlighting will switch off automatically after 2
s. of inactivity.
2.
On/Off button):
• Press the
(On/Off) button, the front cover of the extractor hood will open. The backlighting of
the button will come on and the hood will begin to operate at low speed. The lamp will also come
on. The backlighting of the
(Decrease),
the (On/Off button) again: the front cover of the hood will close, the backlighting of this button
will go out and the hood will be switched off. Functional operations can only be performed when
the cover is open.
3.
(Lamp) button:
Push the
(Lamp) button, the backlighting of this button and the lamp will come on. If you press
the button again, the backlighting of the button and the lamp will go out. The following operations
can be performed repeatedly.
15
(Increase) and
(Lamp) buttons will come on. Press
EN
Advertenties
Inhoudsopgave
